1.Slab                                2.Get some round blocks   

  a．The slab should be finished           ready at hands．

     within two hours

  b．The slab is made after.

  c．The slab cannot be made

      by machines.

  d．Start it again when the

     making of slab takes more

     than three hours

  3.Place the pressed slab flat until it is leather-hard. Its thickness should not be over 5cm. Pay more attention to the time of holing. Apply the ground glaze first

 4.Put the ropes of clay inside the slab        5.Make four small holes convenient     in order to prevent it from being deformed     for exhibiting. The ground slab      when fired at high temperature.                is  needed.

  6.Color the characters on the                7.Pay attention to the metals

   piece with glazes and some of the             before firing. Remember to  write

   glazes are mixed with a little                down the signature and the date  

   slip. For some parts of the piece,            of making when glazing.

   the second glazing will be done

   after the first layer of glazes are

   dried.Mix it with slip and metal

 8.Exhibition Planning One: The             9. Exhibition Planning Two.

   distance between platforms

   should be enough for three

   visitors at the same time.

 10.Exhibition Planning Three:         11.Exhibition Planning Four：the pieces

    from the wall to the floor.           are grouped together one by one

    It will cover a broader               according to the specific exhibition

    floor and create a sensation.         halls．